FERMAPOR K31

Technical data sheet FERMAPOR K31 A-9230-2-VP / K31 B-4 3 of 6 Sonderhoff Chemicals GmbH Richard-Byrd-Straße 26 50829 Köln • Germany Tel: +49 221 95685 0 Fax +49 221 95685 599 info@sonderhoff.com Created on: 30.01.2009 Created by: 181 / 175 Revision: J /13.10..2015 Typical properties of the system FERMAPOR K31 A-9230-2-VP with K31 B-4 in a gravimetric mixing ratio 4.5 : 1 Note to specification authors The following information is not intended for the compilation of specifications, and is to be taken as an aid for initial orientation. For assistance with the compilation of specifications, please contact the Application Technique Division at Sonderhoff Chemicals (see pg. 6 for contact information ). Parameter Standards Value Unit Basic raw material Viscosity (A-component) DIN 1652, Brookfield 50000 mPa*s Viscosity (B-component) DIN 1652, Brookfield 250 mPa*s Density (A-component) DIN EN ISO 2811-1 1.03 g/cm³ Density (B-component) DIN EN ISO 2811-1 1.20 g/cm³ Mixed * Pot life PV-111 50 Sec. Tack-free time PV-111 7 Min. Cured * Colour - black - Density DIN EN ISO 845 0.32 g/cm 3 Surface hardness DIN 53505 and ASTM D 2240 60 Shore 00 Surface hardness DIN 53505 and ASTM D 2240 12 Shore A *Note: The measurement parameters listed are non-binding! They are not to be seen as guaranteed properties of a foam seal applied on a component. The information shown above applies to a cupshot weighing 10 – 20 grams and is intended as a rough orientation aid. It is not a replacement for detailed testing for the respective application.